Authentic Mil-Spec Webbing | Made in the USA to meet Berry Amendment requirements and MIL-W-17337 military specifications, giving you material you can trust for professional builds.
Sizing | Measures 2 inches wide and fits standard 2-inch buckles, slides, D-rings, and ladder locks.
Lasting Ranger Green Color | Solution-dyed for consistent color from batch to batch, a deep shade that resists fading, and low IR/NIR reflectivity.
Tough Everyday Performance | Resists abrasion and absorbs little water, ready for tactical bags, vests, belts, harnesses, and strap repairs. Not for climbing; do not exceed 25% of tensile strength.
Create. Craft. Sew. Empowering Creativity Since 2003. | Trusted webbing, ribbon & hardware - plus helpful guidance - for crafters, sewists, and small businesses.
Build gear that meets real military standards with 2 Inch Ranger Green Solution Dyed Nylon Webbing. Made in the USA, this webbing meets Berry Amendment requirements and conforms to MIL-W-17337 military specifications. You get genuine mil-spec material, not a lookalike, so it fits right into government contracts, professional gear builds, and any project where verified sourcing matters. Every roll is backed by Country Brook Design's commitment to quality and a friendly support team ready to help you choose the right webbing for your build.
Measuring a full 2 inches wide, this heavy-duty nylon webbing is woven for strength and long service life. The Ranger Green color is solution dyed, which means the pigment is mixed directly into the nylon before the fibers are formed. As a result, color runs through every strand instead of sitting on the surface, giving you excellent shade matching from one batch to the next and rich color that holds up to wear. Solution dyeing also gives the webbing low IR/NIR (infrared) reflectivity, a key feature for gear used in low-light or night vision settings. Built for tough conditions, the webbing resists abrasion and sunlight-related fading and absorbs very little water, so it stays lighter and dries faster. Pair it with any 2-inch hardware, including side release buckles, tri-glides, D-rings, ladder locks, and cam buckles.
Choose this webbing for tactical bags, vests, gear straps, utility belts, harnesses, and general equipment reinforcement. It also works well for heavy-duty dog collars, leashes, and other pet gear built for active use. For clean ends, cut with a hot knife or seal the edges with heat to prevent fraying. Please note that this webbing is not suitable for climbing, rappelling, fall arrest, or lifting people. Keep working loads at or below 25% of the rated tensile strength, and inspect your webbing for wear before each use. Factory splices may be present in longer lengths, so check your roll and cut around any splice before building load-bearing parts. Always supervise pets while they wear webbing gear.
